Tech Tip: Frequency Measurement

Avatar

OphirBlog

When measuring pulsed beams with the NanoScan, it is important to input the correct pulse rate into the software. Often this is not the value that the laser manufacturer reports or that the user remembers.

For this reason the NanoScan will actually measure and report the pulse repetition rate. Use this number in the software acquisition set up, and the results will be much better: https://www.ophiropt.com/laser-measurement-instruments/beam-profilers/knowledge-center/tech-tips/how-to-profile-pulsed-lasers

Avatar

OphirBlog

471 posts

Contact us

Leave a Reply

Your email address will not be published. Required fields are marked *

Your email will not be displayed in the comments. Only approved comments will be displayed.

Cookies & Privacy – This site uses cookies to help optimize your browsing experience.
RefusePrivacy PolicyAccept